EFI Intake Manifold
Cast Iron Intake
Manifold – I bought several of these manifolds to use on GMC engines
with fuel injection. I had the area between the primary and
secondary ports ground away to make re-positioning the Throttle Body
forward a bit easier. This is the last one I have set
up for EFI. Note the lack of a hole for the choke heater assembly makes it a
natural for blocking the cross over. Also no EGR Valve.
This manifold has been bead blasted and checked for cracks. I
can remove the small amounts of surface rust and paint for an additional
$25.
Cost $100 plus
shipping.